jbas

Journal of Basic & Applied Sciences

Effect of Cyclone on the Composition of Rainfall at Karachi City
Pages 81-89
Sumayya Saied, Saiyada Shadiah Masood, Azhar Siddique, Haider Abbas Khwaja, Muhammad Kamran Khan and Mirza M. Hussain

DOI:http://dx.doi.org/10.6000/1927-5129.2015.11.11

Published: 06 February 2015

Open Access

Abstract: A rapid urbanization results in increased levels of atmospheric pollutants and magnitude of this increase is much higher in the cities of developing world. Speciation of chemicals in rainwater is one way to assess the degree and nature of atmospheric contaminant accumulation and sources of these contaminants. In June 2010 an episode of heavy rain in the megacity of Karachi occurred due to the impact of Cyclone PHET, which was expected to hit Karachi city along the Arabian Sea. Cyclone impacted rainwater samples were collected from all over Karachi city and analyzed by chromatographic and spectroscopic techniques. A wide range of concentrations were observed among different sites i.e. pH (range 6.13 - 7.92, average 7.31), conductivity (range 9µS/cm - 154µS/cm), major anions F- (0 - 9.22µeq/L), Cl- (31.7 - 184.7µeq/L), NO3- (2.2 - 13.7µeq/L), SO42- (9.3 - 614µeq/L) and cations Ca2+ (13.1 - 364.3µeq/L), Mg2+ (5.83 - 72.65µeq/L), Na+ (49.1 - 344.7µeq/L), NH4+ (0.86 - 58.59µeq/L) and K+ (0 - 61.44µeq/L). This wide variation of distribution was attributed to the long range transportation and climatic conditions due to cyclone effect. Industrial area samples showed a dominating character of industrial influence whereas residential areas were influenced more with the coastal impact. Spatial interpolations were used to interpret the chemical data on geographical maps using ArcGIS®.

Keywords: Rainwater, cyclone, urbanization, industrialization, contaminants.
Download Full Article

Journal of Basic & Applied Sciences

Effect of Wind Shear Coefficient for the Vertical Extrapolation of Wind Speed Data and its Impact on the Viability of Wind Energy Project
Pages 90-100
Saif ur Rehman, MuhammadShoaib, Imran Siddiqui, Firoz Ahmed, Muhammad Rashid Tanveer and Saif Uddin Jilani

DOI:http://dx.doi.org/10.6000/1927-5129.2015.11.12

Published: 06 February 2015

Open Access

Abstract: The importance of characterizing the wind shear at a specified location for the utilization of wind turbine is of vital importance. Such study is considered necessary both for the turbine design and prediction of its power output. In situations where the wind speed at different heights is required if measured values are known at one height then, generally it is extrapolated to the hub height by using the one-seventh power law. The exponent in this case has a value of 1/7 but it is observed that, the value of exponent varies with the type of terrain therefore; the one-seventh power law is not suitable for wind speed extrapolation and energy estimation. It has been found that, the one-seventh power law has a tendency to miscalculate the actual long-term average wind speeds. Hence, for accurate estimation of wind speed at a height, both monthly or seasonal and diurnal values of wind shear coefficient (WSC) have to be used. In this paper, the power law exponent for three sites located over coastal sites in South of Pakistan, i.e., Katibandar, Jati and Gharo, is established using wind speeds measured at heights 10 m and 30 m above the ground (AGL). Wind data is obtained from Pakistan Meteorological Department (PMD). Mean values of WSC were found to be 0.318 at Jati, 0.321 at Gharo and 0.269 at KatiBander. In addition, yearly, monthly and diurnal variation for WSC is also analyzed. The research showed that, the wind shear coefficient significantly fluctuates by seasonal and diurnal changes. Comparisons has been made for discrepancies in energy estimation, payback period and cost of energy (Cents/Kwh) using wind speed values extrapolated from 10 m, for one-seventh power law and overall mean WSC as exponent. The study showed that, if wind speed is extrapolated with WSC of 0.143, the energy is underestimated by 16-33% at Gharo, 12-25% at Katibandar and 28-51% at Jati for all considered hub heights. Error in the Payback period is estimation as 19–34% at Gharo, 16–27% at Katibandar and 31–48% at Jati for all considered hub heights, for 10 m wind data extrapolated with WSC of 0.143. The percentage change in the COE estimation for the two wind shear factors and three sites under study show that, if 10 m wind data extrapolated with WSC 0.143, the COE overestimated is between 19-34% for Gharo, 16-27% for Katibandar and 31- 48% for Jati for all considered hub heights. It is evident from results that, the 1/7 power law, tends to produce misleading results for the feasibility study.

Keywords: Wind energy yield, Wind shear coefficients, coastal sites, Southern Pakistan, one-seventh power law, capacity factors.
Download Full Article

Journal of Basic & Applied Sciences

Study of Urban Heat Island of Karachi by Using Finite Volume Mesoscale Model
Pages 101-105
Sajjad Hussain Sajjad, Nadège Blond, Rabia Batool, Safdar Ali Shirazi, Khadija Shakrullah and M. Nasar Bhalli

DOI:http://dx.doi.org/10.6000/1927-5129.2015.11.13

Published: 06 February 2015

Open Access

Abstract: Karachi is the largest and most populous metropolitan city of Pakistan and the main seaport and financial centre of the country. Rapid urbanization during last 40 to 50 years caused to accelerate its population to 23.7 million. The objective of this work was to study the impact of urbanization on development of urban heat island (UHI) of Karachi city. The study was conducted by using Finite Volume Mesoscale Model (FVM) in which topography from GTOPO30, land-use from GLC 2000 and Meteorological data from NCEP were used as an input to run the simulation. The simulations were run for three days starting at 00:00 (GMT) on 19th day of April and ending at 00:00 (GMT) on 22nd day of April over selected domain with resolution of 3x3 km of 30 cells. The results showed that there is significance urban heat island presence in Karachi city where the urban area has 5.6°C to 13.5°C higher temperature than its surrounding non-urban areas depending upon the time of a day.

Keywords: Urbanization, Finite Volume Mesoscale Model, Karachi, urban heat island.
Download Full Article

Journal of Basic & Applied Sciences

Weibull Distribution Function for Wind Energy Estimation of Gharo (Sindh)
Pages 106-114
Muhammad Shoaib, Imran Siddiqui, Firoz Ahmed, Saif ur Rehman, Muhammad Rashid Tanveer and Saif Uddin Jilani

DOI:http://dx.doi.org/10.6000/1927-5129.2015.11.14

Published: 06 February 2015

Open Access

Abstract: Weibull distribution function is fitted to a measured wind speed data set at mast height of 30 m and Gharo-Sindh (Pakistan) is selected as a case site under study. Wind speed data recorded in one minute interval for the year 2004 is used to estimate Weibull parameters (k and c). Weibull parameters are calculated using Modified Maximum Likelihood Method (MMLM), Maximum likelihood Method (MLM) and Method of Moment (MoM) and the results obtained are compared. Kolomogorov-Smirnov test, Root Mean Square Error (RMSE) and R2 tests are performed to test the goodness-of-fit of the Weibull distribution function. The analysis is based on recorded monthly and yearly wind speed data. Goodness-of-fit tests indicate a better performance of MMLM and MLM as compared to MoM. Wind power density is estimated for the site under study using MMLM and Weibull function estimator. A lowest Weibull mean wind speed of 3.73 m/s in the month of October and highest value of 7.90 m/s for August are observed and correspondingly power densities of 80.95 W/m2 and 425.87 W/m2 are obtained. Descriptive statistics for the measured wind speed data is also evaluated.

Keywords: Weibull function, Shape and Scale Parameters, Gharo-Sindh Pakistan, FUUAST.
Download Full Article